Table of Contents
Advertisement
Available languages
Available languages
DIRECTIONS FOR USE
SET Up
Select a firm, level, flat location - at least six inches (15 cm) from any wall or object for proper air
flow. Place the humidifier on a water-resistant surface, as water can damage furniture and some
flooring. Do not place unit directly on carpet, towels, blankets or other absorbent surfaces.
Guardian Technologies will not accept responsibility for damage caused by water spillage.
FILLING
Make sure unit is unplugged.
1. Separate the tank from the
base of the unit.
3. Pour cool, clean water directly
into the tank. Do not pour anything
but water into the tank.
5. Attach the tank to the base of the
unit and plug in.
E-6
2. Flip over water tank and open the
tank lid, turning it to the left.
4. Close the tank lid, turning it to the right.
It is important to FIRMLY secure cap after
filling the tank with water.
COOL
OFF
WARM
POWER
6. power button
Before turning on make sure there
is water in the unit. Turn the
Power button.
DIRECTIONS FOR USE
CONTROL OpERATION
LIGHT
NO WATER
1. Night Light Feature
Turn Night Lamp dial to illuminate
the night light.
COOL
OFF
WARM
POWER
3. Cool or Warm Humidification Indicator
Select cool or warm mist. Water
temperature is maintained at room
temperature for cool setting and
80 degrees for warm. Allow 15 minutes
for water to warm.
Rotates
separately
5. Humidity Spout Dual Direction
Broaden mist in two different
directions throughout the room by
rotating top section.
2. Variable Mist Control Dial
Turn the Mist Control dial to select
the amount of mist you prefer.
LIGHT
NO WATER
4. Water Refill Indicator
When the unit is low on water the Refill
LED on the front panel will light up, and
the unit will shut off. Simply add more
water to continue use. Unit will
automatically resume running when
water tank has been refilled.
E-7
Advertisement
Table of Contents
