Jacuzzi J-100 Owner's Manual page 21

7. Set Spa To Heat
To warm spa water to a comfortable temperature,
follow these steps:
• The LED display on the control panel displays the
actual temperature of the spa water. Press either the
COOLER (
temperature for 5 seconds. If you want the water to heat to a different
temperature, simply press COOLER (
seconds. The set temperature increases or decreases by one degree
each time one of these buttons is pressed.
• The heater will turn off when the temperature corresponding to the
thermostat setting is achieved.
Important Heater Details:
• The maximum water temperature setting for your spa is 104°F
(40°C) and the minimum setting is 65°F (18°C).
• For North America spas connected to a 40 amp service, jets pump
#1 must be set to low speed and jets pump #2 must be turned off to
operate the heater.
• For Export spas connected to a 20 amp service, jets pump #1 must
be set to low speed and jets pump #2 must be turned off to operate
the heater.
• Setting the thermostat at maximum will not accelerate the heating
process. This will only result in a higher ultimate temperature.
• The heater operates until the water reaches the programmed "set
temperature," then turns off. The heater will reactivate after the
water cools to approximately 1.5° below the set temperature.
8. Place Cover On Spa
• Keeping the insulating cover in place anytime the spa is not in
use will reduce the time required for heating, thereby minimizing
operating costs.
• The time required for initial heat-up will vary depending on the
starting water temperature.
DANGER:
!
Check water temperature carefully before entering hot tub!
Excessive water temperature can cause burns, welts and
body temperature to rise, hyperthermia (over-heating).
) or WARMER (
RISK OF PERSONAL INJURY.
) button once to display the "set"
) or WARMER (
J-100
) within 5
17