Spa Fill Up Procedure - Jacuzzi J-100 Owner's Manual

Figure-C
RED
1
BLK
2
Green
North American 240V Models:
240 VAC, 3-Wire Connection 60 Hz
Congratulations! You are now all set to get your new spa ready to use.
Simply follow the step-by-step procedure in Section 8.0, before long,
you will be enjoying your first glorious experience in your Jacuzzi J-100
Collection spa.
8.0

Spa Fill Up Procedure

For best results, read each step in its entirety before proceeding with that
step.
1. Prepare The Spa For Filling
• Clear all debris from the spa. (Although the spa shell has been
polished at the factory, you may want to treat it with a specially
formulated spa cleaner.) Consult your authorized Jacuzzi dealer for
additional information prior to filling spa.
• Remove filter cover, then remove filter cartridge as outlined in
Section 12.1 (page 26).
2. Fill Spa
• Place the end of your garden hose into the empty filter bucket.
CAUTION: TO DECREASE BUILD UP ON COMPONENTS AND
MINIMIZE ACRYLIC DAMAGE.
Never fill with water from a water softener. If your water is extremely
"hard," it is preferable to fill half-way with hard water and the rest of
the way with softened water. Water that is too soft can be corrosive
to metal components.
!
WARNING:
•
DISEASE.
Fill hot tub with clean tap water from garden hose, to reduce risk of
contracting a waterborne illness (e.g. an infection, bacteria or virus)
and/or respiratory ailments. Fill until water covers all jets but does not
touch the bottom of the lowest headrest. (DO NOT OVERFILL!)
RED
TB1
RED
BLK
BLK
to Circuit
Board
TB3
TO DECREASE RISK OF INFECTION OR
Figure-D
1
2
1
2
Green
All Export Models: 230 VAC, 3-Wire
Connection 50 Hz
J-100
TB2
For Heater
(for a two
breaker
connection)
BLUE
TB1
BLUE
BROWN
BROWN
to Circuit
TB1
Board
TB3
15