Yamaha DRIVE 2 SUPER HAULER 2019 Owner's/Operator's Manual page 42

MAINTENANCE
OPERATING INSTRUCTIONS
1. PLUG AC CORD INTO A
GROUNDED RECEPTACLE
2. PLUG DC CORD INTO DC
CHARGER RECEPTACLE
3. CHARGE CYCLE WILL BEGIN
AFTER A FEW SECONDS AND
AMMETER WILL TURN ON
4. CHARGER SHUTS OFF AUTO-
MATICALLY WHEN BATTERIES
ARE CHARGED
Connect charger's AC cord set to AC
power. Then, connect the DC cord
set plug to the vehicle charging
receptacle by grasping the plug
handle and pushing the plug straight
into the DC charger receptacle. The
charger will start automatically.
Upon connection to AC power
source, the lower four LEDs come
on as a Power-On Self-Test, then the
AC power LED turns on. Upon
connection to battery pack, output
indicators turn on to indicate charging
is active.
8
8-14
Y-669c
J2F