Electrical Connection; Environmental Concerns; Manufacturer - IKEA SMAKLIG User Manual

ENGLISH

Electrical connection

Electrical connection must be made before connecting the
appliance to the electricity supply.
Installation must be carried out by qualified personnel who
know the current safety and installation regulations. Specifically,
installation must be carried out in compliance with the
regulations of the local electricity supply company.
230V 2L 2N ~
T
L1 = R : black
L2 = S : brown
N = N : blue
N = T : blue (grey)
= E : yellow / green

Environmental concerns

WARNING! Ensure that the appliance
is switched off and disconnected from
the power supply before performing any
maintenance operation; never use steam
cleaning equipment - risk of electric shock.
Do not use abrasive or corrosive
products, chlorine-based cleaners or pan
scourers.
DISPOSAL OF PACKAGING MATERIALS
The packaging material is 100% recyclable and is marked with
the recycle symbol . The various parts of the packaging must
therefore be disposed of responsibility and in full compliance
with local authority regulations governing waste disposal.
DISPOSAL OF HOUSEHOLD APPLIANCES
This appliance is manufactured with recyclable or reusable
materials. Dispose of it in accordance with local waste disposal
regulations. For further information on the treatment, recovery
and recycling of household electrical appliances, contact your
local authority, the collection service for household waste or
the store where you purchased the appliance. This appliance
is marked in compliance with European Directive 2012/19/EU,
Waste Electrical and Electronic Equipment (WEEE). By ensuring
this product is disposed of correctly, you will help prevent
negative consequences for the environment and human health.
The symbol on the product or on the accompanying
documentation indicates that it should not be treated as
domestic waste but must be taken to an appropriate collection
center for the recycling of electrical and electronic equipment.

Manufacturer

Ikea of Sweden AB - SE - 343 81 Älmhult, Sweden
N+T
L1 = R : black
L2 = S : brown
N = N : blue
N = T : blue (grey)
= E : yellow / green
Make sure the voltage specified on the data plate located on the
bottom of the appliance is the same as that of the home.
Regulations require that the appliance be earthed: use
conductors (including the earth conductor) of the appropriate
size only. The product is supplied with the mains cable
H05V2V2-F which conforms to Standard IEC/EN 60335-2-6.
IE
L1
N+T
L1 = R : black
L1 = S : brown
N = N : blue
N = T : blue (grey)
= E : yellow / green
ENERGY SAVING TIPSs
Make the most of your hot plate's residual heat by switching it
off a few minutes before you finish cooking.
The base of your pot or pan should cover the hot plate
completely; a container that is smaller than the hot plate will
cause energy to be wasted.
Cover your pots and pans with tight-fitting lids while cooking
and use as little water as possible. Cooking with the lid off will
greatly increase energy consumption.
Use only flat-bottomed pots and pans.
DECLARATION OF CONFORMITY
This appliance meets the Eco Design requirements of European
Regulations n. 66/2014 in conformity to the European standard
EN 60350-2.
BE 220-240V 3 ~
L3
N+T
L1 = R : black
L2 = S : brown
N = N : blue
N = T : blue (grey)
= E : yellow / green
n
12