Desa Comfort Glow CGFB32CB Safety Information And Installation Manual page 10

INSTALLATION
Continued
6. While firmly holding edges of brass trim
together, tighten both set screws on the
adjusting plate with slotted screwdriver.
7. Repeat steps 1 through 6 for other side.
8. Tighten trim hanging screws (#10 x 6.25
shoulder) into holes in cabinets. Place
the assembled trim onto fireplace cabinet.
Align hanging notches on trim with hang-
ing screws on side of fireplace (see Figure
12). Push trim firmly into place, sliding
hanging notches over hanging screws.
Side Brass
Adjusting
Trim
Plate
Slot
Mitered Edge
f i r e - p a r t s . c o m
Figure 11 - Assembling Brass Trim
Assembled
Brass Trim
Figure 12 - Attaching Brass Trim to
Fireplace
INstAllING FIRePlAce hood
Notice: the firebox canopy
(hood) must not be modified or
replaced with a canopy (hood)
that may be provided with the un-
vented decorative room heater.
1. Attach 3 zinc-colored shoulder screws to
back of hood.
2. Insert hood into hood-mounting slots on
firebox.
10
Top Brass Trim
Set Screws
Shim
Slot
Trim Hanging
Screws
Hanging
Notches
on Trim
www.desatech.com
3. Hold hood in place. Insert 2 black Phil-
lips screws through bottom of hood and
tighten. See Figure 13.
Hood
Figure 13 - Installing Fireplace Hood
INstAllING FIRePlAce scReeN
1. Insert each rod through 9 rings located at
top of screen (see Figure 14).
2. Insert first rod into rear hole in left side of
firebox. Fasten rod to rear hole near center
of firebox using black shoulder screw.
3. Insert other rod into front hole on right
side of firebox and fasten using remaining
shoulder screw.
Screw
Front and
Rear Hole
Rod
Ring
Screen
Figure 14 - Installing Fireplace Screen
fireBox iNstallatioN usiNG
oPtIoNAl AccessoRy MANtels
This firebox may be installed using the corner
or cabinet mantel with hearth base against
a wall in your home. A perimeter trim kit is
included with the mantel accessories (see
Accessories, page 12).
Built-iN fireBox iNstallatioN
Built-in installation of this firebox involves in-
stalling firebox into a framed-in enclosure. This
makes the front of firebox flush with wall. Optional
Hood
Mounting
Slot
Shoulder
Screw
Screw
116548-01H