Panasonic EP-MS41 Operating Instructions Manual page 98

2 How to move the unit
Since the unit is very heavy (approximately 48 kg), be careful to avoid back injuries. (The unit must be carried by two persons.)
Put the unit down slowly and carefully watch your step.
See Warning No. 13 on page 2.
Lifting the unit to install and setup the unit
• You may damage the floor by dropping the unit if you do not hold it correctly.
• Check that the leg/foot massage section is stored away and locked.
Place the controller and power cord on the seat.
Hold the sides of the
main unit.
Using the wheels to install and setup the
unit
Mat
The hold position is
the same as that shown
in "At the front".
Do not hold here.
Doing so may result
in damage or injury.
7
EP-MS41_ASIA.indb 7
Placement area (place a mat
to protect the floor. )
Lift it no higher than
waist height.
Place the controller and
power cord on the seat.
Wheels
In narrow corridors etc., hold the front and rear of the
main unit.
Do not hold here.
Doing so may result
in damage or injury.
Placement area (place a
mat to protect the floor. )
At the front
Hold the stiff metal part
within the main unit.
If the clearance is not large enough to
pass through
Try the following.
Before installation, check to see if the clearance is wide
enough and if there is enough space in front of and behind
the clearance.
Also, be careful not to hit the unit against the wall or a
column during the installation.
1 With the unit laying on its side, pass the unit through
the clearance, front end first.
A Width of the space in front of
the clearance:
Over 86 cm from one edge of
the clearance is required.
B Clearance:
Over 65 cm is required.
C Width of the space after the
clearance:
Over 98 cm from one edge of
the clearance is required.
2 Pass the unit through the
clearance while rotating the
unit.
Place the controller and
power cord on the seat.
Hook your fingers on the
dent under the main unit.
<Shown from top>
C
A
B
2014-10-21 13:21:08