Honeywell Home Lynx 5210 Quick Reference Manual

1. To set your alarm when leaving home:

a. Close doors and windows until a green ready light appears on the
security system panel.
b. Press the icon that says ARM AWAY and enter your four digit user code.
c. The keypad will begin to beep. Exit the home, close the door, and lock
it behind you.

2. To disarm the system when you return home:

a. Press the icon that says DISARM and enter your four digit user code.

3. To set the alarm with a delay when at home:

a. Close doors and windows until a green ready light appears on the
security system panel.
b. Press the icon that says STAY, and then enter your four digit user code.

4. In the morning, or before opening any protected door or window:

a. Press the icon that says DISARM, and then enter your four digit user
code.
5. To set the alarm when at home with no delay (night mode):
a. Press the icon that says DELAY. The security system panel should then
read INSTANT.
b. Press the STAY icon and enter your four digit user code.
Continued on Back
6. If an alarm has been triggered:
a. Before proceeding, verify that the alarm was triggered accidentally. If you aren't
sure, wait for the phone call from central station.
Lynx 5210
quick reference guide