Table of Contents
Advertisement
G2E140-AG02-05
3.2 Nominal data
Motor
M2E068-DF
Phase
1~
Nominal voltage / VAC
230
Frequency / Hz
50
Method of obtaining
ml
data
Valid for approval/
CE
standard
-1
Speed (rpm) / min
2000
Power consumption / W
200
Current draw / A
0.88
Capacitor / µF
4
Capacitor voltage / VDB
400
Capacitor standard
S2 (CE)
Min. back pressure / Pa
100
Min. ambient
-25
temperature / °C
Max. ambient
50
temperature / °C
Starting current / A
1.2
ml = Max. load · me = Max. efficiency · fa = Free air
cs = Customer specification · ce = Customer equipment
Subject to change
3.3 Technical description
Weight
3.7 kg
Size
140 mm
Motor size
68
Rotor surface
Painted black
Impeller material
Sheet aluminum
Housing material
Die-cast aluminum
Direction of rotation
Counterclockwise, viewed toward rotor
Degree of protection
IP20
Insulation class
"F"
Moisture (F) /
H0 - dry environment
Environmental (H)
protection class
Installation position
Any
Condensation
None, open rotor
drainage holes
Mode
S1
Motor bearing
Ball bearing
Touch current
< 0.75 mA
according to IEC
60990 (measuring
circuit Fig. 4, TN
system)
Electrical hookup
Terminal strip; Via terminals, capacitor
connected
Motor protection
Thermal overload protector (TOP)
internally connected
Protection class
I (with customer connection of protective
earth)
Motor capacitor
S2
according to EN 60252-
1 in safety protection
class
Item no. 11283-5-9970 · ENU · Change 202174 · Approved 2018-12-28 · Page 5 / 10
ebm-papst Mulfingen GmbH & Co. KG · Bachmühle 2 · D-74673 Mulfingen · Phone +49 (0) 7938 81-0 · Fax +49 (0) 7938 81-110 · info1@de.ebmpapst.com · www.ebmpapst.com
Operating instructions
Conformity with
standards
Approval
; Use the device in accordance with its degree of protection.
Information on surface quality
The surfaces of the products conform to the generally applicable industrial
standard. The surface quality may change during the production period.
This has no effect on strength, dimensional stability and dimensional
accuracy.
The color pigments in the paints used perceptibly react to UV light over
the course of time. This does not however in any way affect the
technical properties of the products. The product is to be protected against
UV radiation to prevent the formation of patches and fading. Changes in
color are not a reason for complaint and are not covered by the warranty.
3.4 Mounting data
; Secure the screws against unintentional loosening (e.g. use self-
locking screws).
For screw clearance, see Chapter 3.1 Product drawing
Strength class of
screws
Any further mounting data required can be taken from the product
drawing or Section Chapter 4.1 Mechanical connection.
3.5 Transport and storage conditions
Max. permitted
ambient temp. for
motor (transport/
storage)
Min. permitted
ambient temp. for
motor (transport/
storage)
EN 60335-1; CE
CCC; EAC
With regard to cyclic speed loads, note that the rotating parts of
the device are designed for a maximum of one million load
cycles. If you have special questions, consult ebm-papst for
support.
8.8
+ 80 °C
- 40 °C
Advertisement
Table of Contents
