Advertisement
Battery
Information
Battery Installation
Engine
• Locate the battery compartment on the
back of the engine
• Loosen the screws in the battery
compartment door with a Phillips
screwdriver. Lift the battery compart-
ment door and insert three "AAA" (LR03)
alkaline batteries.
• Close the battery compartment door and
tighten the screws with a Phillips
screwdriver. Do not over-tighten.
IMPORTANT! Under normal use conditions, the batteries in the engine will require
replacement more often than the batteries in the remote controller. For additional
information, see the troubleshooting section.
Remote Controller
• Locate the battery compartment on the side of
the remote controller.
• Loosen the screw in the battery compartment
door with a Phillips screwdriver. Remove the
battery compartment door and insert three
"AAA" (LR03) alkaline batteries.
• Replace the battery compartment door and
tighten the screw with a Phillips screwdriver.
Do not over-tighten.
Battery Safety Information
Batteries may leak fluids that can cause a chemical burn injury or ruin your toy. To avoid
battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of
non-use. Always remove exhausted
batteries from the toy. Dispose of batteries
safely. Do not dispose of batteries in a fire.
The batteries may explode or leak.
1.5V x 6
"AAA" (LR03)
SHOWN ACTUAL SIZE
We recommend the use of alkaline batteries
for longer battery life
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
toy before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
.
Advertisement
