Table of Contents
Advertisement
R2E220-AA44-98
3.2 Nominal data
Motor
M2E068-BF
Phase
1~
Nominal voltage / VAC
115
Frequency / Hz
50
Method of obtaining
fa
data
Valid for approval/
CE
standard
-1
Speed (rpm) / min
2550
Power consumption / W
75
Current draw / A
0.67
Capacitor / µF
10
Capacitor voltage / VDB
220
Min. back pressure / Pa
0
Min. ambient
-25
temperature / °C
Max. ambient
30
temperature / °C
Starting current / A
1.0
ml = Max. load · me = Max. efficiency · fa = Free air
cs = Customer specification · ce = Customer equipment
Subject to change
3.3 Technical description
Weight
1.3 kg
Size
220 mm
Motor size
68
Rotor surface
Unpainted
Impeller material
PA plastic
Number of blades
11
Direction of rotation
Clockwise, viewed toward rotor
Degree of protection
IP44; installation- and position-dependent
Insulation class
"B"
Moisture (F) /
H0 - dry environment
Environmental (H)
protection class
Installation position
Any
Condensation
None
drainage holes
Mode
S1
Motor bearing
Ball bearing
Touch current
< 0.75 mA
according to IEC
60990 (measuring
circuit Fig. 4, TN
system)
Electrical hookup
Connector with cable
Motor protection
Thermal overload protector (TOP)
internally connected
with cable
Variable
Protection class
I (if the protective earth is connected by
the customer to the marked PE
connection point)
Conformity with
EN 60335-1; CE
standards
Approval
CSA C22.2 No. 113; CCC; UL 507
Item no. 11544-5-9970 · ENU · Change 202174 · Approved 2019-01-03 · Page 6 / 11
ebm-papst Mulfingen GmbH & Co. KG · Bachmühle 2 · D-74673 Mulfingen · Phone +49 (0) 7938 81-0 · Fax +49 (0) 7938 81-110 · info1@de.ebmpapst.com · www.ebmpapst.com
Operating instructions
1~
; Use the device in accordance with its degree of protection.
115
60
Information on surface quality
The surfaces of the products conform to the generally applicable industrial
fa
standard. The surface quality may change during the production period.
This has no effect on strength, dimensional stability and dimensional
CE
accuracy.
The color pigments in the paints used perceptibly react to UV light over
2700
the course of time. This does not however in any way affect the
100
technical properties of the products. The product is to be protected against
0.88
UV radiation to prevent the formation of patches and fading. Changes in
10
color are not a reason for complaint and are not covered by the warranty.
220
0
3.4 Mounting data
-25
; Secure the screws against unintentional loosening (e.g. use self-
30
For screw clearance, see Chapter 3.1 Product drawing
1.05
Strength class of
screws
Any further mounting data required can be taken from the product
drawing or Section Chapter 4.1 Mechanical connection.
3.5 Transport and storage conditions
Max. permitted
ambient temp. for
motor (transport/
storage)
Min. permitted
ambient temp. for
motor (transport/
storage)
With regard to cyclic speed loads, note that the rotating parts of
the device are designed for a maximum of one million load
cycles. If you have special questions, consult ebm-papst for
support.
locking screws).
8.8
+ 80 °C
- 40 °C
Advertisement
Table of Contents
