Commands For Pressure Sensors (P•Xchange) - AML Oceanographic AML-1 RT User Manual

Temperature SET TEMPAVG x
averaging
2.2.2 Commands for Pressure Sensors (P•Xchange)
When paired with a pressure sensor, the device will stream measurements in units of dBar.
The table below summarizes typically used commands for P•X2change sensors.
Table 3: Common Settings for P•X2change
Setting Applicable Command
Identify DISPLAY VERSION
firmware
version
Baud rate SEC 652
SET BAUD x
Automonitor SET AUTOMONITOR xxx
Taring the ZERO
sensor
Data format SET DATAFORMAT xy
Pressure SET SAMPLESTOAVERAGE x
averaging
AML Oceanographic Ltd.
temperature.
This is a secure command, and
must be preceded with 'SEC 652'.
Rolling 'boxcar' average.
Continuously averages last 'x'
samples. Note: increasing averages
will smooth output data but reduce
response time.
TM
sensors
Description
Will provide sensor name and
installed firmware version
X is desired baud rate. Effective
immediately (without power cycle).
Does not alter ident. header baud
rate.
Instrument will start to stream data
after user interrupt, time specified
in milliseconds of inactivity
Will automatically tare the sensor
by applying current readings as an
offset. This command should be
applied while the sensor is in air.
X is number of digits before
decimal. Y is number of digits after
decimal.
Rolling 'boxcar' average.
Continuously averages last 'x'
samples. Note: increasing
averages will smooth output data
but reduce response time.
4 1-100
Default Alternate
Options
- -
9600 9600, 19200,
38400, 57600
115200
0s, will User
not start configurable up
streaming to 100s
- -
2 4
1 1-4096
11/18