Lantronix EDS3000PS Quick Start Manual

EDS3000PS Device Server Quick Start Guide
!
Thank you for choosing Lantronix. Please register the EDS3000PS in order to receive notifications for
firmware and documentation updates at www.lantronix.com/product-registration.
WHAT'S IN THE BOX
Quick Start
START
1. HARDWARE OVERVIEW
EDS3016PS Front View
Console Port
LEDs
Blinking = EDS is transmitting data on the
Transmit (Green)
serial port.
Blinking = EDS is receiving data on the
Receive (Orange)
serial port.
Fast blink= Initial startup, loading OS.
Slow blink (once per second) = Operating
Diagnostic (Green)
system startup.
ON = Unit has finished booting.
Power (Blue) ON = EDS is receiving power.
2. INSTALLATION
1. Power off the serial device that will be connected to the EDS3000PS.
2. Attach a RJ 45 serial cable between the EDS3000PS and your serial
device.
3. Connect an CAT5E Ethernet cable between the EDS3000PS Ethernet
port and your Ethernet network.
4. Connect the power cord and apply power.
5. Power up the serial device.
EDS3000PS
EDS3008PS, EDS3016PS
Transmit LED
Receive LED
Diagnostic LED
Power LED
Description
Accessories
Power Cord, 125 V
AC/10 A - 6 ft cord length
Networking cable, RJ45- DB9
Female Cable to DTE Device,
6 ft length
Other adapters are available and are sold
separately.
EDS3016PS Back View
RJ45 Serial Port
RJ45 Ethernet Port
Ethernet LEDs
Left LED Right LED
OFF No Link
OFF
OFF Link 10Mbps or 100Mbps
ON
OFF Activity 10Mbps or 100Mbps
Blinking
ON Link 1000Mbps
ON
ON Activity 1000Mbps
Blinking
Part Number
500-215-R
500-103-R
Ethernet LEDs
Reset Switch
Power Connector
Description
RS-232 Pin Assignment
1. RTS (Out)
2. DTR (Out)
3. TX (Out)
4. GND
5. GND
6. RX (In)
7. DSR (In)
8. CTS (In)