Hansa FCGW5 Series Instruction Manual page 21

CLEANING AND MAINTENANCE
Door removal
In order to obtain easier access to the oven
chamber for cleaning, it is possible to remove
the door. To do this, tilt the safety catch part of
the hinge upwards. Close the door lightly, lift
and pull it out towards you. In order to fit the
door back on to the cooker, do the inverse.
When fitting, ensure that the notch of the
hinge is correctly placed on the protrusion
of the hinge holder. After the door is fitted to
the oven, the safety catch should be carefully
lowered down again. If the safety catch is not
set it may cause damage to the hinge when
closing the door.
Tilting the hinge safety catches
Removing the inner panel
1. Use a cross-head screwdriver to turn the
side clamp bolts loose (fig. A).
2. Push the clamps off with a flat screw-
driver. Pull the upper door slat loose.
(fig. A, B).
3. Pull the inner glass panel from its seat
(in the lower section of the door) (fig.
C).
4. Clean the panel with warm water with
some cleaning agent added.
Carry out the same in reverse order to
reassemble the inner glass panel. Its
smooth surface shall be pointed up-
wards.
A
B
C
Removal of the internal glass panel
21