Black & Decker BWAC06WT Instruction Manual page 18

SET UP & USE
1. POWER: Turns the air conditioner on and off.
2. COOL: Press the COOL button to COOL mode.
AND : Use these buttons on the control panel and remote to increase or
3.
decrease the set temperature or timer. Temperature range: 61˚F~88˚F or 16˚C~31˚C.
4. SLEEP: Press the SLEEP button, the sleep light will be on after 10 seconds, and
all the left lights will be off. In SLEEP mode, the air conditioner will automatically
adjust the temperature and fan speed to make the room more comfortable during
the night. The set temperature will automatically raise by 1˚C every 30-60 minutes
and at most change six times until the set temperature is 28˚C. And every running
time depends on the set temperature.
5. TIMER: Use these buttons on the control panel and remote to set the timer.
Timer Off: The timed stop is programmed by pressing TIMER button. Set the stop
time by pressing the button " " or " " until the stop time displayed is to your
choosing. Then press TIMER button again.
Timer On: When the unit is off, press TIMER button once and set the desired
temperature by pressing the button " " or " ". Press TIMER button a second time
and set the stop time by pressing the button " " or " ". Press TIMER button a third
time to confirm the setting.
NOTE: Timer can be set to automatically turn off or on from 30 minutes to 24
hours. Each press of the " " or " " buttons will increase or decrease the
timer. The timer can be set in 30 minute increments below 10 hours and
1 hour increments for 10 hours of above. The SET light will turn on while
setting. To cancel the set function, press the TIMER button again.
6. AUTO: Press AUTO button to enter into AUTO mode directly. In this mode the
fan speed and the temperature are set automatically according to the room
temperature (tested by the temperature sensor which is incorporated in the indoor
unit).
7. FAN SPEED: Press the FAN button to choose the fan speed options. You can
choose between 3 speeds and auto mode. Three fan speeds are Hi, Med and Lo.
8. DISPLAY: To press the DISPLAY button, it can switch off/on all lights of LED display.
9. ECO: When the unit is in ECO mode, the indicator light on the display will turn
on. In ECO mode, the compressor will turn off once the room is cooled to the set
temperature but fan will continue to run in 10 minute segments. The compressor
will turn back on when the room temperature rises above the user set temperature.
10. FAN ONLY: Press the FAN ONLY button to FAN ONLY mode.
Page 18