Black & Decker BWAC06WT Instruction Manual page 16

SET UP & USE
4. MODE BUTTON: Press the mode button to cycle through the various modes: Cool,
Dry, Fan and Auto.
Cool Mode: The cooling function allows the air conditioner to cool the room and at
the same time reduces air humidify. Press the MODE button to activate the COOL
mode. To optimize the function of the air conditioner, adjust the temperature and
the speed by pressing the button indicated.
Dry Mode: This function reduces the humidity of the air to make the room more
comfortable. Press MODE button to set the DRY mode. An automatic function of
alternating cooling cycles and fan will be activated.
Fan Mode: Allows the air conditioner to help with room ventilation. Press MODE
button to set the FAN mode. With pressing FAN SPEED button, the speed changes
in the following sequence: Hi, Med and Lo in FAN mode. The remote control also
stores the speed that was set in the previous mode of operation. In AUTO mode,
the unit automatically chooses the fan speed and the mode of operation (COOL,
DRY or FAN).
5. TIMER BUTTON: Use these buttons on the control panel and remote to set the
timer.
Timer Off: The timed stop is programmed by pressing TIMER button. Set the stop
time by pressing the button " " or " " until the stop time displayed is to your
choosing. Then press TIMER button again.
Timer On: When the unit is off, press TIMER button once and set the desired
temperature by pressing the button " " or " ". Press TIMER button a second time
and set the stop time by pressing the button " " or " ". Press TIMER button a third
time to confirm the setting.
NOTE: Timer can be set to automatically turn off or on from 30 minutes to 24
hours. Each press of the " " or " " buttons will increase or decrease the
timer. The timer can be set in 30 minute increments below 10 hours and
1 hour increments for 10 hours of above. The SET light will turn on while
setting. To cancel the set function, press the TIMER button again.
6. ECO BUTTON: When the unit is in ECO mode, the indicator light on the display will
turn on. In ECO mode, the compressor will turn off once the room is cooled to the
set temperature but fan will continue to run in 10 minute segments. The compressor
will turn back on when the room temperature rises above the user set temperature.
7. SLEEP BUTTON: Press the SLEEP button and the sleep light will illuminate after 10
seconds and all other indicator lights will be off. In SLEEP mode, the air conditioner
will automatically adjust the temperature and fan speed to make the room more
comfortable during the night. The set temperature will automatically raise by 1˚C
(1.8˚F) every 30-60 minutes and at most change six times or reaches a maximum
temperature of 28˚C (82˚F).
8. FAN SPEED BUTTON: Press the FAN SPEED button to choose the fan speed
options. You can choose Hi, Med, Low in FAN mode.
9. FILTER BUTTON: After the compressor works for 500 total hours, the filter check
light will turn on to remind the user to clean the filter. When the filter check light is
off, it is useless to press the filter check button. When the filter check light is on, it
can be turned off by pressing the filter check button.
Page 16