Table Of Contents - Viessmann Vitoradial 300-T Service Instructions Manual

Steps - commissioning, inspection and maintenance
Commissioning steps
Inspection steps
Maintenance steps
•
1. Settings at the boiler control unit..................................................................................... 10
• • •
2. Check the connections to the neutralising system. Filling with neutralising agent.... 10
•
3. Commissioning the system............................................................................................... 10
•
4. Checking the burner adjustment...................................................................................... 11
• •
5. Shutting down the system................................................................................................. 11
• •
6. Opening the boiler door..................................................................................................... 12
•
7. Cleaning the internal pipes and heating surface............................................................ 12
• • •
8. Checking the gaskets and packing cords on the flue gas side
• •
9. Checking the thermal insulation components on the boiler door................................. 13
•
10. Inserting the internal pipes............................................................................................... 13
• •
11. Fitting the boiler door........................................................................................................ 14
• • •
12. Checking connections and sensor well on the heating water side for tightness
• • • 13. Checking the function of the safety equipment.............................................................. 14
• • •
14. Checking the function of the pressure switch................................................................ 14
• • •
15. Checking the temperature controller setting if a building management system is
used (DCC system)............................................................................................................ 15
• • •
16. Checking the expansion vessel and system pressure................................................... 15
• • •
17. Checking the firm seating of electrical plug-in connections and cable grommets
• • •
18. Checking the heat exchanger gasket............................................................................... 16
• •
19. Cleaning the flue outlet and heat exchanger................................................................... 18
• •
20. Checking the water quality................................................................................................ 19
• •
21. Checking the neutralising system according to the manufacturer's instructions;
replacing used agent
• •
22. Cleaning the sight glass in the boiler door...................................................................... 19
• • •
23. Checking the mixer for ease of operation and tightness............................................... 19
•
24. Return temperature raising facility................................................................................... 19
• • •
25. Checking the installation room ventilation
• • •
26. Checking the flue pipe and all connections from the heat exchanger to the flue
system for tightness.......................................................................................................... 19
• •
27. Restarting the system
• •
28. Adjusting the burner.......................................................................................................... 20
• 29. Instructing the system user.............................................................................................. 21
•
30. Operating and service documents................................................................................... 21
Commissioning, inspection, maintenance
Page
9