Pure Fun 9302DAK Product Manual page 4

ASSEMBLY INSTRUCTIONS
1
C
A
E
2
3
C
A
F
B
D
E
Side View
1. Locate all legs of the trampoline to install
the wind stakes. In order to keep the
F
trampoline properly grounded you must
place stakes evenly distributed around the
trampoline as pictured to the right.
EXAMPLE:
B
Locate Letters A, B, C, D, E, & F on the
image shown as an example of where the
Wind Stakes can properly be attached.
D
Top View
2. To install the Wind Stakes, locate the
middle of the U-Shaped Leg and point the
legs of the Stakes towards the ground.
3. Using a rubber mallet, hammer the Stake
into the ground by hitting the upper knob
of the Wind Stake. Do this until the arch is
touching the leg of the U-Shaped Leg.
NOTE:
Do not use any tool other than a rubber
mallet to hammer the Wind Stake into
the ground, failure to do this will break or
crack the product.
4. Repeat Steps 1-3 until all Wind Stakes
have been successfully secured into
their respective U-Shaped Legs of the
Trampoline.
4