Table of Contents
Advertisement
Sleep State LED
This allows you to determine the state the Power LED will use when the system
enters the sleep mode. Setting options: [Single] [Dual] [Blink]. Default value:
[Blink]
Blink Power LED will blink when the system enters the sleep mode.
Single Power LED will always remain lit.
Dual Power LED will change its color when the system enters the
sleep mode.
PWRON After PWR-Fail
This allows you to set whether you want your system to reboot after the power
has been interrupted. [Off] leaves your system off and [On] reboots the system.
[Former-sts] leaves the system in the former status. Setting options: [Off] [On]
[Former-sts]. Default value: [off]
Wake Up On PME
This allows your computer to be booted from another computer via a network
by sending a wake-up frame or signal. Setting options: [Enabled] [Disabled].
Default value: [Disabled]
Wake Up On Ring/LAN
To use this function, you need a Modem which supprts power on functions.
During the default value of [Disabled], the system cannot be booted up from
modem and ignores any incoming call from modem. During [Enabled], the
system can be booted up through modem.
Modem Use IRQ
This determines the IRQ in which the MODEM can use. Setting options: [3]
[4] [5] [7] [9] [10] [11] [NA]. Default value: [3].
3-21
®
AWORD
BIOS Setup
Advertisement
Chapters
Table of Contents
