Table of Contents
Advertisement
Getting started
Wall mount installation
The charger is ready for tabletop use. If you want to mount
the charger on a wall, use two 10mm screws and wall anchors
(not provided) to hold the charger in place. The screws and
wall anchors are available for purchase in many hardware or
consumer electronics retailers. You might need a professional to
install the charger.
To mount the charger on the wall
1.
Use a pencil to mark the desired positions of the two holes
on the wall, make sure the space between the two holes is
30mm. Drill two holes in the wall according to the marks. Cut
out the wall mount installation card at the back of this user's
manual for measurement.
2.
If you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than a stud, insert
the wall anchors (not provided) into the holes and tap gently
on the ends with a hammer until the wall anchors are flush
with the wall.
Screw spacing 30mm
(1.18 inches)
8
Advertisement
Table of Contents
