Table of Contents
Advertisement
Hardware Setup
Connector
Fan Power Header: SYSFAN1
The fan power connectors support system cooling fan with +12V. When connecting
the wire to the connectors, always note that the red wire is the positive and should
be connected to the +12V; the black wire is Ground and should be connected to
GND. If the motherboard has a System Hardware Monitor chipset onboard, you
must use a specially designed fan with speed sensor to take advantage of the
CPU fan control.
Important
Fan cooler sets with 3- or 4-pin power connector are both available.
Serial ATA Connector: JSATA1, JSATA2
This connector is a high-speed Serial ATA interface port. Each connector can
connect to one Serial ATA device.
Important
Please do not fold the SATA cable into a 90-degree angle. Otherwise, data loss
may occur during transmission.
2-6
Advertisement
Chapters
Table of Contents
