Table of Contents
Advertisement
5. Set Client Bridge associate to ESSID
"Main_AP" with corrent Pre-shared key. Then
click Next button.
6. Select Disable to deactivate Repeater AP.
Then click Finish button.
7. Wait 35 seconds while the Access Point
reboots.
8. Click Status->Remote AP, the Connection
Information should be display.
Note :
1. To verify wired network of Client Station can access Main Base Station, use ping command to "192.168.2.254"
2. If you can not access Main Base Station, verify the IP address of the wired client (PC or Laptop) is in the same subnet with
Main Base Station.
10
Advertisement
Table of Contents
