Package Contents - Netio PowerPDU 8QS QIG Quick Installation Manual

Package contents:

 NETIO PowerPDU 8QS device
 Quick Installation Guide (QIG)
Status / control indication
1) 1x RJ45 LAN jack
2) RJ45 LEDs – device states (yellow and green)
3) Multifunction "TGL/RESET" button
4) M2M activity LED (red)
5) DI (Digital Input) connector with auxiliary 12V DC power
6) IEC-320 C20 connector for the input power cable
7) Switched sockets (IEC-320 C13)
RJ45 – green LED
RJ45 – yellow LED
M2M (red) LED
Output test
Restoring factory defaults
 Rack mount brackets with screws
 Mount set (4x bolt/washer/cage-nut)
7
1
2 5
Network Link (lit) + Activity (flashes)
1x flash when the device starts
3x flash when the internal system restarts
Blink when some M2M communication is in progress
Press the "TGL" button 3x rapidly.
– If any of output is On (1) -> Off (0).
– If all outputs are Off (0), All outputs -> On (1).
When powering on the device, hold the "RESET"
button pressed for about 10 seconds, until the yellow
LED on the RJ45 jack flashes 3 times.
3
6
3
4
7