Paper Deck Driver Pcb; Power Supply - Canon PD-82 Service Manual

CHAPTER 3
B. Paper Deck Driver PCB
1) Remove the left cover.
2) Remove the rear cover.
3) Disconnect the 11 connectors.
4) Remove the 2 screws, the 2 PCB holding
pins, and then the paper deck driver
PCB.
Connectors
Screws
PCB holding pins

Paper deck driver PCB

Figure 3-9-2
3 - 24
C. Power Supply
1) Remove the left cover.
2) Remove the rear cover.
3) Remove the connector and 2 screws,
and then take out the power supply by
lifting its left side slightly.
Connector Screws

Power supply

Figure 3-9-3