Configuring The Failover Pair In Windows - Adaptec ANA-62022 User Manual

To add the second port, repeat Step 6.
7
Note: To add multiple ports at one time, hold down the Ctrl
key, select the appropriate ports, and click Add. Only two
ports per group are supported for Failover.
To assign TCP/IP addresses to your ports, refer to
TCP/IP Address on page
Configuring the Failover Pair in Windows NT 4.0
To create Failover pairs in Windows NT 4.0, follow these steps:
From the Available Adaptec Ports list, select the port to be
1
designated as the primary port, and click Add. The port is
added under Primary Port field in the Pair Port list.
To assign a backup to the primary port, select the appropriate
2
port from the Available Adaptec Ports list, and click Add. The
port is added in the Backup Port list.
Click Apply.
3
4 . Create another Failover pair by repeating Steps 1
O
PTIONAL
through 3.
5 . Remove a Failover pair by selecting the port from
O
PTIONAL
the Primary Ports list; then click Remove. Both ports return to
the Available Adaptec Ports list. Click Apply.
Duralink64 Configurations for Windows
4-16.
Assigning the
4-9