Creating Port Aggregation And Fec Groups; Port Aggregation With Fec Groups; Creating Port Aggregation Or Fec Groups In Windows 2000/Xp - Adaptec ANA-62022 User Manual

Creating Port Aggregation and FEC Groups

Port Aggregation with FEC Groups

FEC allows you to fully aggregate two or four ports over transmit
and receive under all protocols. The ports that are configured as
the FEC group must be physically connected to the FEC ports on
the switch. If using a Cisco switch, see your Cisco switch
documentation to configure the ports in FEC Mode.
If you select FEC on the server, the connection type for each port is
automatically configured to 100 Megabits/sec TX/Full Duplex.
You must also configure the ports on the switch (used by the FEC
group) to either Auto Negotiation or 100 Megabits/sec/Full
Duplex Mode.
Keep in mind that with FEC, you can configure a minimum of two
and a maximum of four ports (a Cisco limitation). A three-port
configuration is not available.
Creating Port Aggregation or FEC Groups in Windows
2000/XP
To create Port Aggregation or FEC groups in Windows 2000 and
Windows XP, both with GUI, follow these steps:
1 From the Start menu, point to Settings, and click Control
Panel.
2 In the Control Panel, double-click the Adaptec Duralink icon.
Duralink64 Configurations for Windows
4-13