Stihl FS 40 Instruction Manual page 14

English
1
Fit the thrust plate
N
Turn the mowing head
N
anticlockwise on the shaft (1) as far
as it will go
Retain the shaft
N
Tighten the mowing head
N
NOTICE
Remove the tool that was used to block
the shaft.
Removing the Mowing Head
Retain the shaft
N
Turn the mowing head clockwise
N
12
Fitting Mowing Head without Screw
Mounting
Keep the supplement sheet for the
mowing head in a safe place!
STIHL AutoCut C 6-2
Place the mowing head (2) on the
N
shaft (3) while inserting the internal
hexagon (2) on the hexagon (4)
Hold the mowing head (2) with your
N
hand.
Turn cap (1) clockwise and tighten it
N
firmly by hand.
STIHL PolyCut 6-2, PolyCut 7-3
10
1
2
3
4
Push thrust plate onto the shaft
N
Insert the nut (10) into the mowing
N
head
Turn the mowing head (11)
N
clockwise until it engages the shaft
(5)
Retaining the Shaft
N
Tighten the mowing head
N
WARNING
Nuts that move too easily must be
replaced.
NOTICE
Remove the tool that was used to block
the shaft.
FS 40, FS 40 C, FS 50, FS 50 C
11
5