Specifications - PRO-PULSE CMS174 Operator's Manual

SAFETY INSTRUCTIONS FOR COMPOUND MITRE SAW
REPLACE THE TABLE INSERT WHEN WORN. Excessive tear-out increases

the likelihood of injury from flying debris. When setting the saw at a new angle,
check that due to some mis-alignment, the blade does not cut into the table
insert, rear fence, or another part of your saw.
ALWAYS USE THE BLADE WRENCH to tighten the saw blade onto the arbor.

CONNECT YOUR MITRE SAW TO A DUST COLLECTING DEVICE if possible.

If not, use the dust bag that comes with the tool and empty it regularly.
USE A SAW BLADE SUITED TO THE CUTTING JOB AND MATERIAL TO BE

CUT.
ALWAYS USE TABLE EXTENSIONS AND CLAMPS to support the material

when sawing long work pieces.
THE MATERIAL SHOULD BE PLACED FIRMLY AGAINST THE FENCE AND

TABLE. The turning of the saw blade should force it down against the table and
rearward against the fence during the cut. Movement of the workpiece during the
cut may cause the blade to climb on top of the workpiece and create a kickback.
When this happens, the cutting head may jump out of your hand or the workpiece
fly loose and cause serious injury.
DO NOT START THE SAW WITH THE BLADE IN CONTACT WITH ANY

SURFACE. This may cause the saw to bounce or kick back violently and could
cause injury.
IF MAKING A CUT USING ONE HAND TO HOLD THE SAW, ensure the free

hand is clear of the cutting area.

SPECIFICATIONS

15 Amp - 120 V - 60 Hz motor

No-load speed: 5,000 RPM

Bevel cuts from 0° to 45° left

Mitre cuts from 0° to 45° left/right

10" (255 mm) x 60-tooth carbide-tipped blade,

5/8" (15.9 mm) arbor

Positive mitre stops: 0°, 15°, 22.5°, 30° & 45°

Cutting capacity:

90°cross cut: 2-3/4" x 12-3/16" (70 x 310 mm）

45°mitre cut: 2-3/4" x 8-1/4" (70 x 210 mm)

45°bevel cut: 1-9/16" x 12-3/16" (40 x 310 mm)

45°mitre/bevel cut: 1-9/16" x 8-1/4" (40 x 210 mm)

Accessories:
Blade wrench

2 table extensions

Hold-down clamp

Dust collection bag

17