ITC Compel 690UVX Install Instructions

PARTS/TOOLS NEEDED:
Compel Light
(purchased separately)
IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS.
*Disconnect power before installing, adding or changing any component.
*To avoid a hazard to children, account for all parts and destroy all packing materials.
General Care and Cleaning
Long life and the exceptional performance of any equipment is dependent upon the care it receives. To ensure a long life, proper sanitation, and minimum maintenance costs, these
lights should be thoroughly cleaned, and wiped down weekly, at a minimum. Surfaces may be cleaned with a mild detergent and warm water to protect and maintain their appear-
ance.
•Do not use abrasive cleaners or scouring pads, as these will damage or scratch the light.
•Do not use solvent, oil or acidic-based cleaners on any interior surfaces.
•Do not use steam or high water pressure hoses to wash the lights. These will cause leaks and poor performance or potential failure.
1. Screw Mount Installation:
center line on your mounting surface using a straight edge or
the side of the light. Mark the holes for each mounting clip.
Screw the mounting clip to the mounting surface using the
supplied screws. Do not over torque screws. Over torquing
screws will result in damage to the clips and/or stripped out
holes.
Min: 8"
Max: 18"
Snap light into clips by tilting light into clip.
Compel™ Horizontal Light Install Instructions
Jumper Cables Mounting Brackets
(purchased separately)
For screw mount clips, draw a
Please visit www.itc-us.com for warranty info
3030 Corporate Grove Dr • Hudsonville • MI • 49426
Phone: 616-396-1355 • www.itc-us.com • sales@itc-us.com • Revision 6: 05/29/19
(Part #'s: 690UVX)
UL Approved
Pigtails
Power Supply
(purchased separately)
(purchased separately)
2. Magnetic Mount Installation:
lights, ensuring clip completely attaches to groove on light.
Install light in desired location.
3. Adhesive Mount Installation:
mounting surface with a 50/50 mixture of alcohol and water prior to
installation. For proper adhesion, clips should be mounted between
60°F and 100°F. For more detailed instructions* please refer to the
3M ™ website. Snap clips onto back of light and remove the paper
backing. Press light in place.
*http://www.3m.com/3M/en_US/bonding-and-assembly-us/resources/full-story/?sto-
ryid=b3996cbd-9954-455f-8e72-88e452ca38c0
Power Drill
(not provided)
Snap magnetic clips on to
Make sure clip snaps
over groove
Make sure to clean the