ITC Propel FL01-LL Series Install Instructions

PARTS/TOOLS NEEDED:

IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS
Read all instructions before using this product.
PROPEL SHOULD ONLY BE INSTALLED USING THE FOLLOWING INSTRUCTIONS. FAILURE TO
FOLLOW THESE INSTRUCTIONS WILL VOID THE WARRANTY.
DANGER - To reduce the risk of electric shock; Turn off power, lockout etc. before installation, cleaning or inspection.
WARNING - To reduce the risk of burns, fire, electric shock, or injury to persons:
• Disconnect from power and unmount before servicing.
• For commercial or industrial use only.
• Use this product only for its intended use as decribed in these instructions.
• Installation of this product should be completed by a qualified electrician in accordance with NEC and local codes.
• Never operate this product if it has a damaged cord or plug, if it is not working properly, or if it has been dropped or damaged. Contact
ITC for a replacement.
• Keep the cord away from heated surfaces.
• Luminaire suitable for operation in an ambient temperature between -40°C and 70°C (a mechanical ventilation or cooling system is re-
quired to maintain the temperature within the growing space below 70°C when the luminaire is in operation).
• Do not use outdoors, suitable for dry and/or damp locations. Do not immerse any components.
WARNING - Caution, possible hazardous optical radiation emitted from this product. Do not stare at operating lamp. May be harmful to the
eyes.
ATTENTION
• Selection of material having the proper strength and corrosion resistance for the environment is the responsibilty of the installer.
• Luminaire is not intended for recessed use and should be mounted such that proper ventilation is possible.
• Recommend safety glasses, helmet, leather gloves and suitable personal protective equipment during install.
• For best performance, lights are intended to be mounted 3-4' from plant canopy.
• Wire installation considerations:
- Wires must be routed so that they are not subject to strain and are protected from physical damage.
- Wire must be visible over the entire length, and be used within their rated ampacity as determined for the maximum
temperature of the installed environment specified in these instructions.
Phone: 616-396-1355 • www.itc-us.com • sales@itc-us.com • DOC#: 710-00157 • Rev B: 02.13.20
Propel Linear Light Kit Install Instructions
(Part # FL01-LL -XXXX)
Propel Light & Accessories
Please visit www.itc-us.com for warranty info
3030 Corporate Grove Dr. • Hudsonville • MI • 49426
Screws and/or Zip Ties
(Not provided)