ITC elio Wander Install Instructions

PARTS / TOOLS NEEDED:

Flex Light & Mounting Clips

Safety Instructions

• Disconnect power before installing, adding or changing any component.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• Do not install any luminaire assembly closer than 6" from any combustible materials.

Installation Considerations For All Flexible Lighting Products

• Do not bend lighting more than necessary. Refer to page two for bend radius minimums.
• Only bend the LED ribbon in one natural direction, do not try to bend in an unnatural direction such as twisting.

**Installation Considerations For H Flexible Lighting

• Unroll the entire length of HMTL before installing.
• Start installation at the wire lead end.
• When installing the light on the mounting surface, make sure to push towards the wired end.
• Do not use any roller as that may cause damage to the LED circuit.
1.
Determine installation location and
drill a hole in the mounting surface.
4.
Secure the light in the track by gently
pushing into clips
*Please review the considerations on page 2 to ensure a successful installation.
*HMTL flexible lighting cannot be field cut. Field cutting the light will void the warranty.
Phone: 616-396-1355 • www.itc-us.com • sales@itc-us.com • DOC#: 710-00114 • Rev C: 08/20/20
Wander Flexible Light Install Instructions
Power Drill #6 pan head screws
(not provided) (not provided)
2.
Secure clips to mounting surface
using #6 pan head screws
(not provided).
*Clip spacing is dependant on application, when
going around curves clip spacing should be closer.
5.
Follow the wiring diagram below to wire the light to your system.
Black (+)
Red (R)
Black (-)
Fuse
12V DC (+)
Incoming
12V DC
Power

12V Wiring

For warranty information please visit www.itc-us.com/warranty
3030 Corporate Grove Dr • Hudsonville • MI • 49426
(Part #: HMTLVVKK-LLLWL-10)
Application Specific
Sealant
(not provided)
3.
Feed the wires into the hole and apply
application specific sealant* around the
hole and wires.
HMTL Flex Light
HMTL Flex Light
*Note the RGB lights will not have a white wire
Butt Splices
(not provided)
*Sealant here
Incoming
12V DC
Power
Red (+)
Red (-)
Green (-)
RGBW
Blue (-)
Controller
White (-)*
sold separately
Black (+)
Black (-)