Advertisement
Quick Links
VersiControl Smart
System Plus
Part#: 2300X-KKKK-XX-01
PARTS / TOOLS NEEDED:
VersiControl Smart System Plus
Safety Instructions
• Disconnect power before installing, adding or changing any component.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• Do not install any luminaire assembly closer than 6" from any combustible materials.
• Positive (+) outputs require a fuse if the attached wire leads are not rated to handle the max current.
• This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference
- This device must accept any interferences received, including interference that may cause undesired operation
1.
INSTALL: Determine the installation location for your control module. Make sure to consider the size of the module (7.5"L x 5"W x
1.5"H) when determining your location. Note, it will require room for access and for wiring. Screw the controller in place using four M5
stainless steel screws (not provided) sized appropriately for the substrate material used. Make sure when mounted, that the Blue-
tooth antenna is not obstructed by metal objects.
7.5"
2.
CONNECT CONTROL PAD: If using the control pad (optional),
insert the connector on the control pad into the connector on
the module. Refer to control pad installation instructions for
more detailed information.
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
RGB Lighting
Mounting Screws x 4
(Varies)
Bluetooth Antenna
INSTALLATION INSTRUCTIONS
(not provided)
5"
3.
ZONE WIRE CONNECTIONS: Refer to the diagram below for
reference when wiring the system in step 4. Note, there can be
8 or 10 zone wires coming out of the controller. Each wire has
been individually placed on the grommet of the assembly.
For warranty information please visit www.itc-us.com/warranty-return-policy
Butt Splices
(not provided)
ZONE 2
+
R
G
B
W
+
R
G
B
W
ZONE 1
DOC #: 710-00131 • Rev I • 07/16/24
Power Drill
1.5"
Page 1 of 3
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for ITC VersiControl Smart System Plus 2300-01 Series
Summary of Contents for ITC VersiControl Smart System Plus 2300-01 Series
- Page 1 ZONE 2 ZONE 1 3030 Corporate Grove Dr. For warranty information please visit www.itc-us.com/warranty-return-policy Hudsonville, MI 49426 DOC #: 710-00131 • Rev I • 07/16/24 Phone: 616.396.1355 itc-us.com...
- Page 2 - It is recommended that strain relief be added on all wires to prevent any damage to the lights. - If fuses are not included on the RGB controller then ITC recommends including fuses on each zone output (+) wire.
- Page 3 SHIELDING : Shielded cables can be used. Shielding the component in a metal enclosure is also an option. If you continue to experience EMI issues please contact your ITC sales representative. 3030 Corporate Grove Dr. For warranty information please visit www.itc-us.com/warranty-return-policy Hudsonville, MI 49426 DOC #: 710-00131 •...
Need help?
Do you have a question about the VersiControl Smart System Plus 2300-01 Series and is the answer not in the manual?
Questions and answers