V-fit KPE-12/1 Assembly & User Manual page 21

4
Remove the 2 x M8 x 30mm Allen Bolts (51) and 2 x M8 Spring Washers (52)
from the front of the Handlebar Upright (2).
Attach the Fixed Handbar (8) to the Handlebar Upright (2) Using 2 x M8 x 30mm
Allen Bolts (51), 2 x M8 Spring Washers (52). Fit the Handlebar cover (53) over
the Fixed Handlebar mounting bracket (8).
Fit the correctly labelled (L or R) Dual Action Handlebar - Upper (7L / 7R)
into the appropriate Dual Action Handlebar - Lower (6L / 6R) and secure in place
using 2 x M8 x 40mm Carriage Bolt (45), 2 x M8 Curved Washer (44) and 2 x M8
Dome Nut (58) for each side as shown below.
5
Remove the pre-fitted M4 Flat Washers (54) and M4 x 12mm Screws (55) from
the back of the Exercise Monitor (9).
Connect the wires of the Exercise Monitor (9) to the Exercise Monitor Link Wire (18)
and the Pulse sensor wire (50). Matching like for like
Carefully slide the Exercise Monitor (9) onto the Exercise Monitor Bracket and fit
the 2 x M4 Flat Washers (54) and 2 x M4 x 12mm Screws (55).
Assembly
Note
Ensure that the cables are
securely fitted together as
per the instructions supplied
with the Exercise Monitor.
Page 21