Table of Contents
Advertisement
3Trouble shooting
:
Warning – Risk of injury!
T r o u b l e s h o o t i n g
Incorrect repairs may cause serious hazards. Repairs to
the appliance must only be carried out by a qualified
technician. If repairs are required, contact the after-
sales service.
Fault table
Fault
The appliance does not work.
Zeros flash in the display.
The oven light has failed.
The gas burner does not ignite.
The oven does not heat up.
All dishes that are prepared in the oven burn
within an extremely short period of time.
The door panel steams up when the oven is
hot.
Replacing the oven light bulb
If the oven light bulb fails, it must be replaced.
Replacement heat-resistant bulbs can be obtained from
the after-sales service or from specialist retailers.
Please specify the E number and FD number of your
appliance. Do not use any other type of bulb.
:
Warning – Risk of electric shock!
When replacing the cooking compartment bulb, the
bulb socket contacts are live. Before replacing the bulb,
unplug the appliance from the mains or switch off the
circuit breaker in the fuse box.
Allow the cooking compartment to cool down.
1.
Open the appliance door.
2.
Place a tea towel in the cooking compartment to
3.
prevent damage.
Remove the hook-in racks.
4.
Remove the glass cover. To do this, open the glass
5.
cover at the front with your hand. Should you
experience difficulties removing the glass cover, use
a spoon to help.
Possible cause
The circuit breaker is faulty
Power cut
Power cut
Faulty oven light
Power cut or damp ignition plugs
Faulty fuse.
The function selector has not been set.
Faulty thermostat
Normal occurrence; caused by the difference in
temperature
Remedy/information
Look in the fuse box and check that the circuit
breaker is in working order.
Check whether the kitchen light works.
Reset the time.
Change the oven light bulb. (See section "Replacing
the oven light")
Light the gas burner with a gas lighter or a match.
Check and, if required, replace the circuit breaker.
Set the function selector.
Call the after-sales service.
Not possible; this has no effect on oven perfor-
mance.
Remove the oven light bulb.
6.
Replace the oven light bulb with a bulb of the same
7.
type:
Voltage: 230 V;
Power: 40 W;
Fitting: G9;
Temperature resistance: 300 °C
Refit the glass cover for the oven light bulb.
8.
Refit the hook-in racks.
9.
Remove the tea towel.
10.
Switch the circuit breaker back on.
11.
Check that the oven lighting is working again.
12.
Trouble shooting
en
21
Advertisement
Table of Contents
