Factory Reset; Accessing The Web User Interface - ZeeVee ZyPerPad User Manual

ZyPerPad User Guide

Factory Reset

Accessing the Web User Interface

The ZyPerPad supports a simple to use web user interface to setup the
ZyPerPad and configure commands for the buttons. The Web UI can be
accessed via a browser such as Chrome, Firefox or Safari.
1. Connect the LAN (PoE) port of the ZyPerPad to an Ethernet switch using a
Cat5e cable or better.
~ If the switch supports PoE, the ZyPerPad will receive power from it.
Otherwise, connect a DC 12V power adapter to the
included)
2. Connect a PC to the same network
3. Power on all devices.
4. The default IP address for the ZyPerPad is 192.168.0.101 with a subnet
mask of 255.255.255.0
5. You will be prompted in the browser for a Username and Password. The
default Username and Password are both "admin"
Rev 20211006
Press and hold the 2 bottom buttons
simultaneously and hold for about 8
seconds. This will cause all 10 buttons to
blink 3 times and indicate the ZyPerPad
is being reset to factory defaults.
ZyPerPad.(Not
Page 5 of 26