Using The Programmed Keypad - ZeeVee ZyPerPad User Manual

ZyPerPad User Guide
2. Web Login Timeout default is 10 minutes
3. Download Current Configuration creates a text file that should not be edited.
Editing the file may make restoring not possible.
a. The saved file will be config.ini
b. The user can change the name of the file as long as it begins with
"config"
4. Restore Configuration allows you to select previously saved text file.
a. Note: Restoring configuration will cause the ZyPerPad to reboot.
5. Reset to Default will factory reset the unit.
6. Reboot the Unit will reboot the unit. (Note: All 10 buttons on the ZyPerPad
will flash 3 times during a reboot)
7. Web Upgrade is used to the the Web GUI.
8. MCU Upgrade is used to update the firmware on the ZyPerPad itself.

Using the Programmed Keypad

Once the ZyPerPad unit is programmed; the user can execute commands either
by pressing the button on the unit or by clicking on the button in the Key
Settings screen.
Important Note:
initializes the unit. This initialization will not execute the programmed command.
All button presses after the very first one will execute the command as
expected.
The ZyPerPad can be left powered on indefinitely.
Rev 20211006
Example: config_bar.ini, config_lobby.ini
The very first button press after a power-on or reboot
Page 20 of 26