Table of Contents
Advertisement
52
5
Remove the hard drive from the carrier (A) by removing the four
screws (D) from the slide track (C). Lift the drive out of the carrier
(B).
6
Remove the new hard drive from its wrapper and place it on an
anti-static surface.
7
Set any jumpers and/or switches on the drive according to the
drive manufacturer's instructions.
8
Install the new drive in the carrier and the carrier/drive into the
drive bay (see "Installing a Hard Drive" on page 37).
9
Reinstall a carrier/air baffle in any bays where you are not
reinstalling a carrier/drive.
Replacing a DVD/CD-ROM drive/FDD Module
CAUTION: A DVD/CD-ROM drive/FDD module is NOT hot
swappable. Before replacing it, you must first take the server out
of service, turn off all peripheral devices connected to the system,
turn off the system by pressing the power button, and unplug the
AC power cord from the system or wall outlet.
1
Remove the bezel from the front of the chassis.
2
Rotate the handle bar (A) up about ¼-inch (6-mm) to unlatch the
module from the bay.
4 Working Inside Your Server
Advertisement
Table of Contents
