Table of Contents
Advertisement
38
Caution: To allow proper airflow and server cooling, all drive bays
must contain either a carrier with a hard drive installed or a carrier
with an air baffle installed.
1
If present, remove the front bezel.
2
If the drive carrier is installed in the drive bay, remove it.
3
Remove the air baffle (A) from the drive carrier by removing the
four screws (B) from the slide track (C).
4
Store the air baffle for future reinstallation in the event you must
operate your server without a drive in one of the bays.
5
Remove the hard drive from its wrapper and place it on an anti-
static surface.
6
Set any jumpers and/or switches on the drive according to the
drive manufacturer's instructions.
7
With the drive circuit-side-down (A), position the connector end
(E) so that it is facing the back of the carrier (B).
2 Assembling the System
Advertisement
Table of Contents
