Problems With The Projector - Acer X1160P User Manual

26
9 Image is too small
or too large
10 Image has slanted
sides
11 Image is reversed

Problems with the Projector

# Condition
1 The projector stops responding
to all controls
2 Lamp burns out or makes a
popping sound
•
Adjust the zoom lever on the front of the projector.
(X1160Z/ZC/PZ/PZC, X1260/Z/ZC/P/PZ/PZC/K/KC series)
•
Move the projector closer to or further from the
screen.
•
Press "MENU" on the remote control. Go to "Image
--> Aspect Ratio" and try different settings or
press"Aspect Ratio" on the remote control to adjust
directly.
•
If possible, reposition the projector so that it is
centered on the screen.
•
Press the "Keystone
control until the sides are vertical.
•
Select "Image --> Projection" on the OSD and adjust
the projection direction.
If possible, turn off the projector, then
unplug the power cord and wait at least 30
seconds before reconnecting power.
When the lamp reaches the end of its useful
life, it will burn out and may make a loud
popping sound. If this happens, the projector
will not turn on until the lamp module has
been replaced. To replace the lamp, follow
the procedures in the "Replacing the Lamp"
section.
/ " buttonon the remote
Solution