Problems With The Projector - Acer P7505 User Manual

8
9
10
11

Problems with the Projector

#
1
2
Downloaded From projector-manual.com Acer Manuals
Image is stretched When you play a DVD encoded in anamorphic or 16:9
when displaying a aspect ratio you may need to adjust the following
"widescreen" DVD settings:
title
•
•
•
Image is too small •
or too large
•
•
Image has slanted •
sides
•
•
Image is reversed •
Condition
The projector stops responding
to all controls
Lamp burns out or makes a
popping sound
If you play a 4:3 format DVD title, please change the
format to 4:3 in the projector OSD.
If the image is still stretched, you will also need to
adjust the aspect ratio. Set up the display format to
16:9 (wide) aspect ratio on your DVD player.
If you play an Letterbox (LBX) format DVD title,
please change the format to Letterbox (LBX) in the
projector OSD.
Adjust the zoom ring on the top of the projector.
Move the projector closer to or further from the
screen.
Press "MENU" on the remote control or on the
control panel. Go to "Image --> Aspect Ratio" and
try different settings.
If possible, reposition the projector so that it is
centered on the screen.
Press the "Keystone /
on the remote control until the sides are vertical.
Press the "Keystone" on the OSD until the sides are
vertical.
Select "Image --> Projection" on the OSD and adjust
the projection direction.
If possible, turn off the projector, then
unplug the power cord and wait at least 30
seconds before reconnecting power.
When the lamp reaches the end of its useful
life, it will burn out and may make a loud
popping sound. If this happens, the projector
will not turn on until the lamp module has
been replaced. To replace the lamp, follow
the procedures in the "Replacing the Lamp"
section.
" on the control panel or
Solution
39