PAC MCI-GM52 Quick Start Manual

MCI-GM52
Introduction & Features
The MCI-GM52 will allow the addition of a reverse, blind spot, and one more additional camera in vehicles equipped
with the 7" radio screen.
Important Notes
1. Compatible build code: IOB. Incompatible build codes: IOA, IO4, IO5, and IO6 . Build codes can be found on a silver sticker either in
the glove box or in the trunk near the spare tire well.
2. If you change the DIP switch settings, you must disconnect and reconnect power for the change to take effect.
3. It is very important that you make all connections with the key in the off position. Failure to do so will result in the factory touchscreen
becoming unresponsive. If you do make the connections with the key on, you must turn the vehicle off, shut all doors, and leave it alone
for 5 minutes. After 5 minutes, turn the key back on, and the interface should operate as intended.
4. If you are installing this interface strictly to add a reverse camera, please note that the blind spot inputs will need to be deactivated by
entering the menu and manually disabling the inputs (see page 3 for details)
What's Included
1
2
3
4
5
2
3
Module
Power Harness
Video Input harness
Foam Padding
LVDS Connectors
© 2017 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
4
Not available Separately
Multi Camera Input Interface
for select General Motors Vehicles
2015-2018 with 7" radio screen
1
5
MCI-GM52
BSM2-PTH
BSM2-CEH
Miscellaneous
Rev. 032118
Page 1