Advertisement
MCI-GM52
DIP switches
Set DIP switches according to the descriptions below
Select vehicle year using dip switches.
u 2018
dip switch 1 down
Installation Steps
1.
We recommend performing this installation with the vehicle's battery disconnected. Please consult the vehicle's owners manual
for proper battery disconnection procedure.
2.
Set the DIP switches for your situation based on the functions listed above. These DIP switches must be set to the proper configuration
before connecting the interface to power.
3.
Remove the factory screen assembly and disconnect the factory harnesses along with the LVDS harness from the tuner unit (Fig. A).
Please note that you will be disconnecting the LVDS harness on the right in Fig. A. It is the black plug with the blue cable,
NOT the blue plug with the black cable.
Use the gray and
gold connectors
3.
Connect the MCI-GM52's male harnesses to the factory tuner unit.
4.
Connect the factory harnesses into the female connectors on the MCI-GM52's harnesses.
6.
Connect the MCI-GM52's male LVDS harness to the factory tuner unit.
7.
Connect the factory LVDS harness into the female LVDS connector on the MCI-GM52.
8.
Connect the power harness to the MCI-GM52 module.
9.
Connect the video harness to the MCI-GM52 module.
10. Connect cameras and corresponding camera power wire outputs according to the chart on
the right. If the vehicle is equipped with a factory reverse camera, then Input 3 can be used for
a trailer cam or not at all. Secure and insulate any camera inputs and power wires not being
used to prevent any contact with metal.
11. If necessary, use the provided foam padding to insulate the module from any rattles before
securing inside the dash cavity.
Illustrations are typical and may not match exact vehicle details
Vehicle Year
Vehicle Year
1
2
u 2017
2 up
3 up
4 up
© 2017 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
Vehicle Year
3
dip switch 1 up
2 down
3 up
4 up
Fig. A
PAC-audio.com
Multi Camera Input Interface
for select General Motors Vehicles
2015-2018 with 7" radio screen
Vehicle Year
4
u 2015-2016
dip switch 1 up
Use the black plug
with the blue cable
Camera 1 = Left Camera
Camera 2 = Right Camera
Camera 3 = Trailer Camera
Camera 4 = Optional Camera
Camera 4 input is automatically activated
when vehicle is in reverse gear when
aftermarket camera option is selected in
the installer menu.
Rev. 032118
2 up
3 up
4 up
Page 2
Advertisement
