Festo NEBM-SM12G8-E Q5-LE6 Series Instructions & Assembly

NEBM-SM12G8-E-...-Q5-LE6
Motor cable
Instructions | Assembly
8116064
2019-08c
[8116066]
Translation of the original instructions
1 Applicable documents
All available documents for the product è www.festo.com/pk.
2 Safety
2.1 Safety instructions
– Do not connect or disconnect plug connector when powered.
– Only assemble the product on components that are in a condition to be safely
operated.
– Assembly and installation should only be carried out by qualified personnel.
These personnel have electrical training or a relevant qualification.
2.2 Intended use
Connection of motor EMMS‑ST to suitable controller
3 Configuration
3.1 Product design
Fig. 1
3.2 Contact assignment
Electrical connection 1 Allocation
Field device side
1 Plug con- Pin
nector
1 String A
2 String A/
3 String B
4 String B/
5 Not assigned
6 Not assigned
7 Brake +24V
8 Brake GND
1) Colour code in accordance with IEC 60757:1983-01
Tab. 1 Contact assignment
4 Mounting
4.1 Mounting of electrical connection 1
1. Align the plug 1 to match the socket.
2. Insert the plug 1 into the socket.
3. Tighten the screw-type lock of the plug 1. Tightening torque: 0.1 Nm ± 20 %
4.2 Mounting of electrical connection 2
1. Connect the wires in accordance with the contact assignment.
2. Clamp the screened connection 4 into the spring clip of the controller.
Festo SE & Co. KG
Ruiter Straße 82
73734 Esslingen
Germany
+49 711 347-0
www.festo.com
8116064
1 Plug M12, A-coded
2 Wire end sleeve (8x)
3 Cable
4 Screened connection
Electrical connection 2
Controller side
2 Wire ends
1)
WH
BN
GN
YE
–
–
GY
PK
4.3 Wiring
Feature Cable characteristic
-E- Suitable for energy chains
Tab. 2 Wiring
4.4 Mounting in energy chain
1. Lay the chain out lengthwise.
2. Place the cables in the chain, making sure they are not twisted.
3. Separate cables from each other using separators/drill holes.
4. Do not connect cables together.
Fig. 2
5. Maintain space X. X > 10 % of the cable diameter D.
If the chain is suspended vertically: increase the space X.
Fig. 3
6. Align chain in the operating position:
– Make sure that the radius is greater than the bending radius R of the
cables.
– Cables can move freely in the bending radius KR of the energy chain.
Ä Cables are not forced through the chain.
7. Mount the energy chain è corresponding instructions.
8. Fasten cables:
– At both ends of the chain in case of short energy chains
– Only at the driver end in the case of long, sliding energy chains
Fig. 4
9. Do not bend cables all the way to the fastening point.
Ä Mounting space A between the fastening point and bending movement is
observed.
NOTICE!
Damage to cables if the chain breaks.
• Replace cables after a chain break.
NOTICE!
Malfunction and material damage due to vertically suspended cables.
The cables stretch.
• Regularly check the length of the cables.
• Readjust the cables if required.
Wiring
In energy chain or flexible