Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
•
Remove all packing materials, including the bottom cushions, foam pads, and tape inside the
refrigerator. Tear off all protective film on the doors and on the refrigerator body.
•
Place the refrigerator in a well ventilated place, on flat sturdy ground.
•
Avoid locating the refrigerator in moist or humid areas. Excess moisture in the air may cause
frost to form quickly on the evaporator and cabinet, requiring frequent defrosting.
•
Locate the refrigerator away from direct sunlight and other heat sources. Direct sunlight may
affect the performance of the appliance.
•
The refrigerator should be placed against the wall at least 4" (10cm) of free space to allow for
heat dissipation. There should also be at least 11" (30cm) of space above the appliance, as well.
Before Using your Appliance
1. Keep the refrigerator upright for half an hour before connecting to the power supply.
2. Connect the appliance to a power supply, and let the unit run for 2-3 hours.
NOTE: If the ambient temperature of the room is higher than normal (starting the machine in the
summertime, for example), it may take up to 4 hours to start using the appliance.
Leveling the Appliance
Use the leveling feet to ensure the appliance does not wobble or tip.
•
Turn the feet clockwise to raise the refrigerator, and turn the feet counterclockwise to lower the
refrigerator.
CAUTION: Do no place any additional appliances, such as a microwave, on top of your refrigerator
unless expressly recommended by the manufacturer.
Moving the Appliance
Remove all objects from the appliance before moving. Affix the glass partitions, vegetable holder,
and freezing chamber drawers with tape. Tighten the leveling feet, close the doors, and affix them
with tape. Keep the appliance inclined by more than 45°. DO NOT lay the appliance on its side or
upside down.
6
Advertisement
Table of Contents
