Husqvarna P 520D Operator's Manual page 115

10. Remove the the 2 screws and remove the bottom
plate.
11. Lift of the rubber casing on top of the shaft joint.
12. Pull back the coupling of the drive shaft and remove
the drive shaft from the shaft journal.
13. Remove the lock chains.
14. Remove the pins (A) and the bolts (B) from the lifting
arms.
A
To attach and remove the cabin
1. Disengage the door of the cabin. Refer to
and remove the door on page 116 .
2. Disengage the emergency door of the cabin Refer to
To attach and remove the emergency door on page
116 .
3. Remove the rubber straps and open the engine
cover.
740 - 002 -
B
A
B
To attach
4. Disconnect the battery.
5. Remove the 3 screws and remove the side cover.
6. Remove the 4 screws and remove the protective
cover of the fuse box.
7. Disconnect the cable.
8. Put the rubber grommet in the empty slot.
9. Put a cloth below the hoses for the air condition.
Note: To prevent coolant leakage, make sure the air
condition is disengaged when the hoses are
disconnected.
10. Disconnect the couplings on the hoses for the air
condition.
11. Remove the 2 screws and the 2 washers behind the
seat (A).
12. Remove the screw and the washer behind the hoses
for the air condition (B).
115