Toshiba Carrier MMU-AP0074HPUL Service Manual page 27

No. Item
18 Louver control • If there is the locked louver in the unit, [
(Continued):
• While the following controls are performed, the louvers
• The real louver corresponding to the louver No. displayed
19 DC motor 1) When the fan stator, positioning is performed for the
2) DC motor operates according to the command from
(Note) If the fan rotates by entry of outside air, etc while
(Note) If the fan lock was detected, the operation of the
20 Save operation 1) The function [Save operation] is not provided to the
Outline of specifications
remote controller screen.
operate even if executing the louver lock.
Control which ignores lock
Operation stop
�
When heating operation started
�
Heating thermo. OFF
�
During defrost operation
�
Initialize operation
�
on the remote controller screen during setting of louver
lock operates swinging.
starter and the rotor. (Vibrate slightly)
the indoor controller.
the air conditioner stopped, the indoor unit may
operate as the fan motor stops.
indoor unit stops and the error is displayed.
Super Modular Multi series models.
- 27 -
Remarks
] goes on the For the setting operation,
refer to [How to set louver
lock] of Installation Manual.
Objective louver No.
Horizontal discharge position
Horizontal discharge position
Horizontal discharge position
Horizontal discharge position
Full-close position
It is position check operation
and it does not link with the
real louver and air direction
setup (Illustration on the
remote controller screen).
Check code [P12]
• If pushing [SAVE] button
" " on the remote
controller, "No function"
is displayed.