Sym CRUiSYM A Owner's Manual page 11

○
Odometer
d
This odometer shows the total distance in kilometers the scooter has been ridden.
It cannot be reset.
NOTE :
 The data is maintained in the combination instrument even when the battery is disconnected.
 When the figures come to 99999, they will return to 0, and the odometer starts working again.
 This odometer only shows in kilometers.
○
Multifunction Display
e
When the ignition switch is turned on, battery voltage will display for approximately 10 seconds.
Then the below display mode can be shifted circularly by pushing the S button.
Clock → Battery voltage → Clock...
Push M button to switch the below display mode:
Odometer → Trip meter → Oil meter → Odometer...
Clock
This clock displays only 24-hour mode.
To set the clock, do the below steps:
 Turn the ignition switch on and wait for approximately 10 seconds until the clock displays.
 Push the M button for more than 2 seconds, the hour display starts blinking.
Push the S button to adjust the hours.
 Push the M button. The hour display stops blinking, and the minute display starts blinking.
Push the S button to adjust the tens place in the minute display.
Push the M button. The tens place stops blinking, and the unit display starts blinking.
Push the S button to adjust the units place in the minute display.
 Push M button to finish clock setting.
NOTE :
 When the battery is disconnected, the clock is reset to 12:00 and starts working again when the battery
is reconnected.
 If the clock is idled about 30 seconds while setting, it will exit setting mode automatically and starts
working again.
 If the ignition switch is turned off while setting the clock, the clock will exit setting mode when the
ignition switch is turned on again.
 The clock works normally by the backup power even the ignition switch is turned off.
11