Advertisement
Scan resume time
If 5, 10, or 15 sec is selected, SCAN will start again after 5, 10, or 15
second pause even though a signal is still present.
If P5 is selected, SCAN will stop as long as a signal is present and will
resume SCAN again 5 seconds later.
Auto power OFF
The auto power off function is activated when no buttons are pushed or
PTT activated for this period of time.
The automatic power off time can be set to OFF, 1, 2, 4 hours at menu
mode.
Group Tone setting
The group tone scan default tone selected is CTCSS 01 (67Hz).
You can select from CTCSS 01 - 38 to DCS 01 to 104 code for Group
tone scan.
Factory Reset
If the radio's display locks up or stops functioning properly, you might
need to reset your UHF radio.
Caution: this procedure clears all the information you have stored in
your UHF radio.
Before you reset your UHF radio, try turning it off and on again.
If your UHF radio is still not functioning correctly you may need to reset
the UHF radio.
Operations
21
Advertisement
