Table of Contents
Advertisement
22
www.electrolux.com
13.3 Installing the oven under a
work surface
Before the installation, connect the oven
to the electrical supply. Refer to "Electrical
connection".
During installation in
combustible matter, NIN SEV
1000 and fire protection
guidelines and regulations of
the Association of Cantonal
Fire Insurance shall be strictly
adhered to.
1. Place the appliance in front of the
recess and connect the mains plug.
Make sure the cable is free when you
slide the appliance.
2. Push the appliance into the recess.
A = appliance, N = recess
A
N 560-568 mm
A 592 mm
3. Use a minimum of 2 screws to attach
the oven on the 2 sides (A).
When installing next to a wood-fuelled
boiler, a heat-proof and heat-insulating
plate must be mounted at the height
of the appliance and at least 30 cm
deep.
A
A
180
mm
115 mm
N min.
550 mm
A 567
20
mm
mm
13.4 Electrical connection
Use a power cable of H05VV-F or higher.
Install the appliance with a socket supply
line. If there is no socket supply line, the
fixed home electrical system must include
an isolating device with at least a 3 mm-
contact separation to enable a
simultaneous and all-pole cut off from the
mains (according to NIN SEV 1000). The
customer must have a socket for the
electrical connection that is accessible
B
and outside the coordination room. The
length of the connection cable must be
~50 mm
N 600
approximately 120 cm with lines
mm
connected directly to the mains.
A 595
mm
442 mm
1. Do the electrical connections as in the
connection illustration.
Phase definitions: L1, L2 (or R, S).
Voltage: 400V
2. Secure the cable grip.
A
WARNING!
If service is required always
disconnect the appliance
from the power supply.
Only a qualified person can
connect the appliance to the
electricity supply.
400V 2 ~
PE
L1
L2
1
2
3
5
4
min. 20 mm
B
10
mm
A
20 mm
Advertisement
Table of Contents
