Acer Veriton 5200D Service Manual page 83

BIOS Messages
Memory Size Has Changed Since Last Boot
Memory Verify Error
Offending Address Not Found
Offending Segment
Press A Key To Reboot
Press F1 to Disable NMI, F2 to Reboot
RAM Parity Error
System Halted
Floppy Disk(s) Fail(80)
Floppy Disk(s) Fail (40)
Hard Disk(s) Fail (80)
Hard Disk(s) Fail (40)
Hard Disk(s) Fail (20)
Hard Disk(s) Fail (10)
Hard Disk(s) Fail (08)
Keyboard Is Locked Out
Keyboard Error Or No Keyboard Present
Manufacturing POST loop
BIOS ROM Checksum Error
Memory Test Fail
Chapter 4
Action/FRU
In EISA mode, use Configuration Utility to reconfigure the
memory configuration. In ISA mode, enter Setup and enter
the new memory size in the memory fields.
Use this location along with your system's memory map to
locate the bad chip.
This message is used in conjunction with the I/O
CHANNEL CHECK and RAM PARITY ERROR messages
when the segment that has caused problem cannot be
isolated.
This message is used in conjunction with the I/O
CHANNEL CHECK and RAM PARITY ERROR messages
when the segment that has caused problem cannot be
isolated.
Press any key and the system will reboot.
When the BIOS detects a Non-maskable Interrupt
condition during boot, this will allow you to disable the NMI
and continue to boot, or you can reboot the system with the
NMI enabled.
Checking for segment
Press CTRL + ALT + DEL to reboot.
Or plug out AC and wait for 10 seconds, then plug in AC
again. Press power button to boot the system again.
Unable to reset floppy subsystem
Floppy Type mismatch
HDD reset failed
HDD controller diagnostics failed
HDD initialization error
Unable to recalibrate fixed disk
Sector Verify failed
Unlock the key
Make sure the keyboard is attached correctly and no keys
are pressed during the boot.
System will repeat POST procedure infinitely while the P15
of keyboard controller is pull low. This is also used for M/B
burn in test.
BIOS will boot from the boot block and read BIOS binary
file from FDD disk, then flash BIOS ROM (FWH - Firmware
Hub).
BIOS reports the memory test fail if the onboard memory is
tested error
74